No manual comes with the house, so nobody tells you that winterizing is really just four jobs wearing a longer list: keep the water out, keep the heat in, keep the pipes from freezing, and make sure the furnace won’t fail on the coldest night of the year. Work through it area by area and it stops feeling like a chore and starts feeling like a checklist you can actually finish in a weekend.
When to Start, and Why the Date Matters
The work is the same everywhere; the deadline isn’t. The goal is to finish before the first hard freeze in your area, not before some fixed calendar date. In most of the U.S. that means wrapping up in September and October.
That timing isn’t arbitrary. According to Roots’ maintenance model, the furnace tune-up and the chimney sweep are both scheduled for September by default, and the outdoor faucet shutoff and window and door seal check default to October. Those dates exist because HVAC technicians and chimney sweeps book up fast once the weather turns, and a faucet or hose left connected through the first cold snap can crack a pipe you won’t find until it thaws.
If your winters are mild, you can push these later, but don’t skip them. A single overnight freeze is enough to split a pipe. If this is your first year owning the home, Roots’ first-time homeowner checklist covers the rest of the year, and the seasonal maintenance schedule shows how this fits alongside spring and summer tasks.
Roof and Gutters: Get the Water Moving Away From the House
Everything below this section only matters if water is actually leaving the roof instead of pooling on it. Start here.
Clean the gutters and downspouts, and confirm water is running clear when you flush them with a hose. According to Roots’ maintenance model, gutters need this twice a year, and overflowing gutters rot the fascia board, dump water against the foundation, and are the direct cause of the ice dams that force meltwater under shingles in January. If you want the full walkthrough, Roots’ gutter cleaning guide covers technique and safety.
If you have a wood-burning fireplace, this is also the month for a chimney sweep and inspection. Creosote buildup is a fire hazard, and a blocked flue can push carbon monoxide back into the house instead of up the chimney.
While you’re up there (or looking from the ground with binoculars), check the siding, trim, and exterior caulk for anywhere winter’s freeze-thaw cycles have opened a gap.
Windows and Doors: Stop Paying to Heat the Outside
Inspect the seals on every window and every exterior door. Look for caulk that has cracked, shrunk, or pulled away from the frame, and for weatherstripping that has gone flat or brittle. Failed seals let water into the wall cavity and let heat out of the house, and they’re cheap to fix compared to what happens if you don’t: a gap that lets in water over a winter can mean a repair, not a resealing job, by spring.
This is also the month to check that any door sweeps still make full contact with the threshold. If daylight shows underneath, cold air is getting in too.
Outdoor Plumbing: Faucets, Hoses, and Irrigation
This is the step homeowners skip most often, and it’s the one with the worst downside. Disconnect every garden hose and drain it before storing it. Then shut off each outdoor faucet at its interior valve, if your home has one, and open the outdoor spigot afterward to drain any water left in the line.
The reason this matters: a frozen hose bib bursts the pipe inside the wall, not the faucet itself, so you won’t see the damage until you turn the water back on in spring and find it soaking the drywall. If you have an in-ground irrigation system, it needs a proper blowout with compressed air, which is usually a job for whoever installed it, before the first hard freeze.
The Heating System: Furnace, Filter, and Thermostat
Book the furnace or heat pump tune-up before you need it, not during the first cold week when every technician in town is already booked. A service visit catches problems like a cracked heat exchanger, which is a carbon monoxide risk, before the system is running around the clock. Roots’ HVAC maintenance guide goes deeper on what a technician actually checks.
Replace the filter at the same time, and again every one to three months through the season. According to Roots’ maintenance model, a clogged filter strains the blower and can overheat the furnace, and thinner one-inch filters often need changing monthly rather than quarterly.
Take five minutes to review your thermostat schedule now that heating season is starting, and confirm the batteries and firmware are current if it’s a smart model.
Basement and Crawl Space: Pipes and the Sump Pump
Walk the basement or crawl space and look at any exposed supply pipes for corrosion or damp. Green crust on copper, or dampness at a joint, is the warning sign that appears before a pinhole leak starts soaking the wall cavity behind it, and it’s much cheaper to catch now than after a winter of freeze-thaw stress on that same joint.
Test the sump pump while you’re down there by pouring in a bucket of water and confirming it activates and clears the pit. Pumps fail silently, and a January thaw combined with a dead pump is how basements flood with no warning at all.
If any pipes run through an unheated space, garage walls, a crawl space, or along the rim joist, insulate them now rather than after the first cold snap.
Safety Devices: Test Before You Need Them
Winter is when combustion appliances run the most: the furnace, a gas water heater, maybe a fireplace. Test every smoke and carbon monoxide detector in the house and replace any battery that’s weak. A dead detector protects no one, and the test button takes ten seconds.
If a unit is more than seven to ten years old, replace it outright rather than trusting a fresh battery to fix an aging sensor.
A Simple Order to Work Through It
If you only do this once, work outside to inside: gutters and roof first, then windows and doors, then outdoor faucets and irrigation, then the furnace, then the basement, then detectors. Each step protects the one after it, and none of it takes more than a weekend.
Pick one day this week and start with the gutters. Everything else on this list gets easier once the water has somewhere to go.